En-31
Setting the Clock
1
Press the [TIMER] button repeatedly until
“Clock” appears.
2
Press [ENTER].
3
Use the arrow []/[] buttons to enter the
current hour.
When the CD receiver is shipped from the factory,
the time display format is set to 24-hour time. Set
the current hour as it would appear in 24-hour time.
If you want to set the current hour as 12-hour time,
press the [DISPLAY] button.
4
Press [ENTER].
5
Use the arrow []/[] buttons to enter the
current minute.
6
Press [ENTER].
The clock is set and the second dot starts flashing.
Displaying the Time
To display the time, press the remote controller’s
[CLOCK CALL] button. Press the button again or
perform another operation to cancel the time display.
If the CD receiver is on Standby, the time will be
displayed for 8 seconds.
While the CD receiver is on, the time is displayed
continuously.
Change the time format
To change the time format between 12-hour and 24-hour,
press the [DISPLAY] button.
Setting the Clock
To Next Page
Loading...
Need help?
General
