En-25
Listening to the Radio
When tuned to a station, the Tuned ( ) indicator
appears. When receiving a stereo FM signal, the FM ST
indicator appears as well.
The [MODE] button is used to select Auto mode or
Mono mode. In Auto mode, the output will be stereo or
mono depending on the station being received. In Mono
mode, the output will be mono regardless of the station.
1
Press the [TUNER] button on the remote
controller, or the [INPUT] button on the top
panel, repeatedly to select “FM”.
2
Use the TUNING []/[] buttons to tune
into a station.
Each time you press the TUNING button, the
frequency changes 0.05 MHz steps for FM.
If you press and hold the TUNING button, the
frequency will change continuously. Once you
release the button, tuning will stop automatically
when a frequency on which a radio station is
broadcasting is found. If you want to interrupt this
process, press the [CLEAR] button.
Tuning into weak stereo FM stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, press the
[MODE] button to switch to Mono mode and listen to
the station in mono.
Tuning into FM Radio Stations
To Next Page
Loading...
Need help?
General
