En-15
Connecting Antennas
This section explains how to connect the supplied indoor
FM antenna.
The CD receiver won’t pick up any radio signals if no
antenna is connected, so you must connect the antenna to
use the tuner.
Note:
• Once your CD receiver is ready for use, you’ll need to
tune into a radio station and position the antenna to
achieve the best possible reception.
Tip:
• If you cannot achieve good reception with the
supplied indoor FM antenna, try a commercially
available outdoor FM antenna instead.
Connecting the AM Loop Antenna
The supplied indoor AM loop antenna is for indoor use
only.
1
Assemble the AM loop antenna, inserting
the tabs into the base, as shown.
2
Plug the AM loop
antenna into the
AM antenna jack,
as shown.
■ Adjusting the AM Loop Antenna
Adjust the location and position of
the AM antenna while listening to
an AM station to achieve the best
possible reception.
Connecting Other Components