1717
FIRST SETUP
TV Shape
4:3LB
Thank you for your purchase of Our DVD-Video Player.
Please make a selection
for On-Screen Language and your TV shape and
press ENTER button on your remote control.
On-Screen Language
ENG
FM MODE
STANDBY/ON
STANDBY
POWER
PHONES
OFF
ON
TUNING/PRESET
SURROUND STEREO
T – D
DISPLAY
DVD / CD
PRESET
MEMORY
SUBWOOFER
MODE
SPEAKER
SETUP
SPEAKER
A / B
ACOUSTIC
CONTROL
INPUT
MASTER VOLUME
Connecting the Power/Turning on the DVD
Receiver
Before connecting
• Make sure that all the connections from pages 10 to 16 are complete (the connection to the TV is required).
• Turning on the DVD Receiver may cause a momentary power surge, which might interfere with other electrical equipment such as computers. If
this happens, use a wall outlet on a different circuit.
2 Press the POWER switch to
switch on the main power.
The DVD Receiver enters standby mode.
The STANDBY indicator lights up.
Notes
• To switch off the main power, press the POWER switch again.
• The buttons on the remote controller don’t operate if the POWER
switch is set to OFF.
1 Connect the power cord (mains lead)
to a wall outlet (the mains).
I
N
P
U
T
S
E
L
E
C
T
O
R
M
O
D
E
A
U
D
I
O
D
V
D
T
V
T
A
/
M
D
L
I
S
T
E
N
I
N
G
M
O
D
E
A
.
C
T
R
L
T
–
D
S
T
E
R
E
O
S
U
R
R
T
I
T
L
E
M
E
N
U
S
E
T
U
P
T
V
/
V
C
R
R
E
T
U
R
N
CH
TUN
VOLENTER
REPEAT MUTING
A – B
REC
DIMMER
OPEN/CLOSE
RANDOM SLOW
SUBTITLE – ON / OFF
ANGLE ZOOM
MEMORY CLEAR AUDIO DISPLAY
--
/
---
SW MODE
LATE NIGHT DISTANCE
CH SEL
T– D SETUP
UP/ DOWN
TEST TONE
SP A
SP B
123
456
789
+
10 0
SEARCH
S
T
N
B
Y
O
N
S
L
E
E
P
3 Press STANDBY/ON on the DVD
Receiver or ON on the remote controller.
The DVD Receiver turns on.
The light and display on the DVD Receiver’s
front panel light. At the same time, the
STANDBY indicator goes off.
The first time you turn on the DVD Receiver, the FIRST
SETUP screen appears. In the FIRST SETUP screen, select
the On-Screen Language and TV Shape according to the
aspect ratio of the TV screen (see pages 54 and 55).
1 Press
/ to select “On-Screen Language,” then press
ENTER.
2 Select a language with / , then press ENTER.
3 Press
to select “TV Shape,” then press ENTER.
4 Press
/ to select the aspect ratio of the TV screen,
then press ENTER.
5 Finally press SETUP.
All of your selections are set and the FIRST SETUP
screen disappears.
Notes
• To turn off the DVD Receiver, press STANDBY/ON on the DVD
Receiver, or STNBY on the remote controller. The DVD Receiver
enters standby mode. Be sure to set the volume to minimum before
turning off the DVD Receiver.
• You can change the above settings later with “Customizing the
Function Settings” on page 52.
↔
Before operating the cursor
Press MODE DVD or MODE AUDIO.
ENTER
ENTER
To Next Page
Loading...
Need help?
General
