Need help?Do you have a question about the Onkyo HT-R508 and is the answer not in the manual?
Amplifier Section| rated output power (FTC) | 110 watts |
|---|---|
| rated output power (IEC) | 5 ch × 130 W |
| maximum output power (JEITA) | 5 ch × 160 W |
| dynamic power (3Ω, 1 ch driven) | 210 W |
| dynamic power (4Ω, 1 ch driven) | 190 W |
| dynamic power (8Ω, 1 ch driven) | 130 W |
| total harmonic distortion (THD) | 0.08% |
| damping factor | 60 |
| input sensitivity and impedance | 200 mV/ 47 kΩ |
| output level and impedance | 200 mV/ 470 Ω |
| frequency response | 5 Hz–100 kHz |
| tone control (bass) | ±10 dB, 50 Hz |
| tone control (treble) | ±10 dB, 20 kHz |
| signal to noise ratio | 100 dB |
| speaker impedance | 8Ω–16Ω |
Video Section| input sensitivity/output level and impedance (component and s-video y) | 1 Vp-p /75Ω |
|---|---|
| input sensitivity/output level and impedance (component pb/cb, pr/cr) | 0.7 Vp-p /75Ω |
| input sensitivity/output level and impedance (s-video c) | 0.28 Vp-p /75Ω |
| input sensitivity/output level and impedance (composite) | 1 Vp-p /75Ω |
| component video frequency response | 5 Hz – 50 MHz |
Tuner Section| fm tuning frequency range | 87.5 MHz– 108.0 MHz |
|---|---|
| am tuning frequency range | 522 kHz–1611 kHz |
| radio presets | 40 |
General| power supply | AC 230 V, 50 Hz |
|---|---|
| power consumption | 560 W |
| standby power consumption | 0.3 W |
| dimensions (W × H × D) | 435 × 150 × 377 mm |
| weight | 10.2 kg |
To Next Page
