!
Using the Tuner
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets for
quick selection.
You can also change the frequency steps (_ page 89).
Press AMor FMto select either "AM" or "FM".
In this example, FM has been selected.
Band Frequency
i:::'i':'i _':;_7:; ":::; i';'ii..._":;" ..........
(Actual display depends on the country.)
Tuning into Radio Stations
N Auto tuning mode
1 Press TUNINGMODEso that the AUTO indicator
lights on the AV receiver's display.
2 Press TUNING A/T.
Searching stops when a station is found.
When tuned into a station, the TUNED indicator
lights. When tuned into a stereo FM station, the FM
STEREO indicator lights as shown.
TUNED
• Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. [n this case, switch to
manual tuning mode and listen to the station in mono.
Turning On & Basic Operations
N Manual tuning mode
In manual tuning mode, FM stations will he in mono.
1
2
Press TUNING MODE so that the AUTO indicator
goes off on the AV receiver's display.
Press and hold TUNING &/¥.
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the frequency
one step at a time.
N Tuning into stations by frequency
You can tune into AM and FM stations directly hy entering
the appropriate frequency.
1 On the remote controller, press AM or FM to select
"AM" or "FM", followed by D.TUN.
2
i"" i'- __ ",q"...i...,.
(Actual display depends on the country.)
Within 8 seconds, use the number buttons to enter
the frequency of the radio station.
For example, to tune to 87.5 (FM), press 8, 7, 5 or 8,
7,5,0.
It you have entered the wrong numher, you can retry
after 8 seconds.
En-30
©©
To Next Page
Loading...
Need help?
General
