1 Make sure that each Onkyo component is connected
with an analog audio cable (connection [] in the
hookup examples) (_ page 16).
2 Make the R I connection (see the illustration).
3 If you're using an RI Dock, or cassette tape deck,
change the Input Display (_ page 41).
With fall (Remote Interactive), you can use the following
special functions:
N System On/Auto Power On
When you start playback on a component connected via
1:tI, while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
N Direct Change
When playback is started on a component connected via
1:tI, the AV receiver automatically selects that
component as the input source.
N Remote Control
You can use the AV receiver's remote controller to
control your other 1:tI-capable Onkyo components,
pointing the remote controller at the AV receiver's
remote control sensor instead of the component. You
must enter the appropriate remote control code first
(_ page 70).
RI Dock
• Use only 1"-41cables for 1"-41connections. 1"-41cables are supplied
with Onkyo components.
• Some components have two 1"-41jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional 1"-4I-capable components.
• Connect only Onkyo components to 1"-41jacks. Connecting other
manufacturer's components may cause a malfunction.
• Some components may not support all 1"-41functions. Refer to the
manuals supplied with your Onkyo components.
• While Zone 2 is on, the System On/Auto Power On and Direct
Change 1-41 functions do not work.
Connections
En-17
©©
To Next Page
Loading...
Need help?
General
