m There's no picture
Make sure that all video connecting plugs are pushed 14
ill all the way.
If your TV is connected to the HDMI OOT, select
" ill the "HDMI Input" setup to watch
composite video, and component video sources.
48
If the video source is connected to a composite video 16
input, your TV must be connected to the HDMI OUT
or the correspoudiug composite video output.
On your TV, make sure that the video iuput to which --
the AV receiver is connected is selected.
N The on-screen display does not appear
Depending on the input signal, the on-screen display
may not appear when the input signal from HDMI IN
is output to a device connected to HDMI OUT.
43
N Reception is noisy, FM stereo reception is noisy,
or the FM STEREO indicator doesn't light
Relocate your auteuua.
Listeu to the statiou iu mouo. 3O
Passiug cars aud airplaues cau cause iuterfereuce. --
Make stare you've selected the correct remote
coutroller anode.
Make stare you've entered the correct remote control
code.
N Can't control other components
[f it's an Oukyo compoueut, make sure that the 1"-41
cable and analog audio cable are connected properly.
Connecting only an 1-41 cable won't be enough.
Appendix
10, 70
69
17
N There's no picture from a source connected to
an HDMI IN
Reliable operatiou with an HDMI-to-DVI adapter is 88
not guarauteed. In addition, video siguals from a PC
are not guarauteed.
If nothing improves the reception, install an outdoor --
autelnm.
q
N The remote controller doesn't work
Before operatiug this unit, be stare to press
RECEIVER.
If you've connected an cassette tape deck to the
TWCD IN jack, or an R[ Dock to the TWCD IN or
GAME IN jacks, for the remote controller to work
properly, you must set the input display
appropriately.
To control another manufacturer's component, poiut
the remote coutroller at that compoueut.
41
69
ff the message "Resolution Error" appears on the
AV receiver's display, this indicates that your TV
does not support the current video resolution and you
need to select another resolution on your DVD
player.
N The on-screen menus don't appear
On your TV, make sure that the video iuput to which --
the AV receiver is connected is selected.
Install new batteries. Dou't mix different types of
batteries, or old aud uew batteries.
Make stare that the AV receiver is not subjected to
direct sunshine or iuvertea-type fluorescent lights.
Relocate if necessary.
To control an Oukyo component that's not connected 70
via 1"-4I, point the remote controller at the component.
Be sure to enter the appropriate remote control code
first.
En-75
©©
To Next Page
Loading...
Need help?
General
