Update Procedure
/ Press RECEIVER followed by HOMEon the remote
controller.
The Home menu appears on the TV screen.
2 Select "Firmware Update" and press ENTER.
Note that the "Firmware Update" option will he
grayed out for a short while after the AV receiver is
turned on. Please wait until it becomes operable.
3 Select "Update via NET" and press ENTER.
Note that this option will not be available it there is no
firmware file newer than the currently installed
version.
4 Select "Update" and press ENTER.
The update process will begin.
During the update process, the on-screen display may
disappear depending on the updated program. When
this occurs, you can still view the update progress on
the AV receiver's display. The on-screen display will
reappear alter the update is complete, and upon
turning the AV receiver off and on again.
5 Tile message "Completed!" appears on tile AV
receiver's display, indicating that the update has
been completed.
6
Turn off the AV receiver using _ON/STAN DBY on
the front panel.
Do not use _3RECEIVER on the remote controller.
Once turned off, the AV receiver will automatically
turn on again.
Congratulations! You now have the latest firmware
installed on your Onkyo AV receiver.
Troubleshooting
Case 1:
If an error occurs, "Error!! *-**" is displayed on the AV
receiver's display. (Alpha-numeric characters on the front
display are denoted by asterisks.) Refer to the fonowing
table and take appropriate action.
m Errors during an update via network
*-10, *-20
*=11, *=13, *=21,
*-28
Others
The Ethernet cable was not detected.
Reconnect the cable properly.
[nternet connection error.
Check the following items:
Make sure the [P address, subnet mask,
gateway address, and DNS server are
configured properly.
Make sure the router is turned on.
Make sure the AV receiver and the router are
connected with an Ethernet cable.
Make sure your router is configured properly.
See the instruction manual of the router.
lYyour network allows only one client
connection and there is any other device
already connected, the AV receiver will not be
able to access the network. Consult your
[nternet Service Provider (ISP).
If your modem does not function as a router,
you will need a router. Depending on your
network, you may need to configure the proxy
server if necessary. See the document
provided by your [SP. If you are still unable to
access the [nternet, the DNS or proxy server
may be temporarily down. Contact your [SP.
Retry the update procedure from the beginning.
If the error persists, please contact Onkyo
Support (3 page 82) and provide the error
code.
Appendix
Case 2:
If an error occurs during the update process, disconnect
then reconnect the AC power cord and try again.
Case 3:
If you do not have an Internet connection to the network,
please contact Onkyo Support (_ page 82).
En-80 V
©©
To Next Page
Loading...
Need help?
General
