Onkyo K-200R User Manual

Common modes of operation
ESS
Check once again that all connections have been completed ex-
actly as indicated in the connections diagram and then turn the
power on. After turning power on, no operations are possible until
the Il Pause indicator has stopped flashing on and off.
Tape Playback
ONEEYO strato casserte TAPE DECK K-200R
a oN aon
®
Depress the Eject button to open the cassette holder.
Insert a cassette with the exposed tape facing down and the
side to be played facing outward. Close the cassette holder.
Set the Dolby NR switch to the proper position for the tape
about to be used.
@ Tapes recorded using Dolby B or C NR must be played back
with the Dolby NR switch in the B or C position, as ap-
propriate.
Set the Reverse Mode Selector switch to the desired tape
transport mode. See the “Reverse mode selector” section.
Press the or al Play button depending on which side of
the cassette you wish to listen to.
The R-200 INPUT SELECTOR will display TAPE.” (See the
®
®
®
®
®
rw
econ mar
con @ ccooo
tae anes
merit nh cont tea
wrens wo eT UE,
zee
ad
O® @®
“Direct function feature” section of the R-200 instruction
manual for details).
Press the li STOP button to stop playback. After tape
transport has stopped and the Peak Levei indicators have
gone out, press the EJECT button to open the cassette holder
and remove the cassette.
Fast Forward and Rewind
Press the > button to wind the tape rapidly forward and the <4
button to wind it rapidly backward. The tape will stop when the
STOP button is pressed or when the end of the tape is reached
(on account of the auto-stop mechanism).
Recording
Recording from Sources other than the CD Player
@ Insert a cassette with the side to be recorded facing out.
Before inserting the cassette, confirm that the erasure preven-
tion tabs are intact (see page 10). If one or both of the tabs is
broken off, recording on the side with the missing tab will not
be possible.
e Operating the unit near a television set can cause hum during
recording or playback. Should this happen, either turn off the
television set or move it away from the cassette deck.
Set the Dolby NR switch to the B or C position if you want to
make a Dolby NR encoded recording.
Set the Reverse Mode Selector switch to the desired ((—) or
(= )) tape transport mode. See the “Reverse mode selector”
section for details.
Press the elapsed time counter RESET button to return the
tape counter to [0:00] so you can index the recording for fu-
ture reference.
)
Press the R-200 INPUT SELECTOR button for the source you
wish to record.
Press the @Al button. The tape will not move, but the Peak
Level indicators will show the level of the signal being
received through the LINE IN jacks.
Use the AUTO/MANUAL button to select either auto or manual
mode. When the auto mode is selected ( [AUTO LEVEL] in-
dicator on) the optimum recording level is set automatically.
If the manual mode is selected ( [AUTO LEVEL] indicator off),
watch the Peak Level indicators and adjust the Input Level
Control knob to the proper position.
Confirm again that an input signal is being received (the Peak
Level indicators should light) and then press the m or ~al Play
button to begin recording.
The auto-stop mechanism will stop tape transport automat-
ically when the end of the tape is reached (depending on the
tape transport mode). To stop recording before the end of the
tape, press the li STOP button. To briefly interrupt recording,
press the @AI button.

Onkyo K-200R Specifications

General

Brand	Onkyo
Model	K-200R
Category	Tape Deck
Language	English