Onkyo K-200R User Manual

Using the Repeat Function (Block Repeat)
Use this function to repeat a song or a specific section up to five
times.
@® Press the m (or ~«l) Play button to begin playback.
@ Press the REPEAT button when the tape reaches the begin-
ning of the block you wish to repeat.
@ The REPEAT indicator flashes on and off. This marks the
beginning of the block to be repeated.
@ Press the REPEAT button once again when the end of the
block to be repeated is reached.
@® The repeat indicator stays on. The portion of the tape be-
tween the point where the REPEAT button was pressed first
and the point where the it was pressed a second time is
played five times in succession. After the fifth time, tape
transport halts at the point at which the REPEAT button was
pressed the second time.
e Note, however, that if the end of the tape is encountered
before you press the REPEAT button the second time, the end
of the tape becomes the endpoint of the block to be repeated.
e Pressing the REPEAT button a third time or pressing any
other operation button, however, cancels the block repeat
function and initiates the new function.
Using the Auto Space Button
This button is useful not only for making recordings from radio
broadcasts but also to eliminate the noise of the stylus making
contact with a record and the noise between selections ona
record,
@ Press the Q (Auto Space) button at any point during a record-
ing where you want to enter a blank section about five
seconds long.
@ The c> (Forward Play) or <a (Reverse Play) indicator flashes
on and off.
@ After the blank section has been inserted, tape transport stops
automatically and the deck returns to the rec/pause standby
mode.
@ The © Recording and Elindicators turn on.
@ To continue recording, press the Play button corresponding
to whichever Direction indicator is on.
® To insert a blank section of tape less than five seconds long,
press the @Alll button to return to the rec/pause standby
mode or press the appropriate Play button before the five
second period has elapsed.
© To insert a blank section of tape more than five seconds long,
hold the © (Auto Space) button down for as long as you want
the blank section to be. The deck will return to the rec/pause
standby mode immediately when the button is released.
@ The Auto Space button works in both the record and
record/pause modes.
@ The Auto Space button is also very convenient for making
silent sections of sufficient length for the proper operation of
automatic sensing systems such as Musie Search.
Music Search Function
@ Press this button to skip ahead to the next selection on the
tape and commence play.
e Then search function does not operate while recording or in
the rec/pause standby mode.
e Search operates by detecting the blank sections between
selections. If the space between two selections is not long
enough, Search will wind the tape to the next blank space of
sufficient length. In ordér to ensure that the blank sections be-
tween selections on your cassettes are of the correct length,
use the Auto Space button to insert these spaces when
making recordings.

Onkyo K-200R Specifications

General

Brand	Onkyo
Model	K-200R
Category	Tape Deck
Language	English