Onkyo K-200R User Manual

Timer Recording and Playback
If the K-200R is used together with the R-200 tuner amplifier, you
can record FM broadcasis at preset times or use the system as an
alarm clock,
1. Timer Recording
TIMER
REC OFF PLAY
@_ Turn power on to the K-200R and R-200 and tune in the sta-
tion you wish to record. (Refer to the R-200 instruction manual
for details.)
2. Timer Playback
TIMER
REC OFF PLAY
Follow the instructions in the “Tape Playback" section on
page 4 to confirm that the cassette loaded in the deck is the
correct one and move the tape to the selection you wish
played first.
Prepare the cassette to be used for recording as described in
the ‘Recording from Sources other than the CD Player” sec-
tion on page 4. If you turn the “Auto” recording level adjust-
ment function on, the optimum recording level will be set
automatically.
With the K-200R and R-200 power switches still on, set the
tuner amplifier timer to turn power on at the time of your
choice. (Refer to the R-200 instruction manual for details.)
Set the Timer Switch to the REC position.
®
®
Notes:
1) If no output from the speakers is required during the actual
recording, turn the volume down ail the way.
2) Be sure the C-200 (CD player) timer switch is in the OFF posi-
tion.
3) The Timer Switch should be left in the OFF position when the
timer function is not required.
@ With the K-200R and R-200 power switches still on, set the
tuner amplifier timer to turn power on at the time of your
choice. (Refer to the R-200 instruction manual for details.)
@® Set the Timer Switch to the PLAY position.
Notes:
1) Set the R-200 volume control to an appropriate level.
2) Be sure the C-200 (CD player) timer switch is in the OFF
position.
Auto-Reverse Operation
Reverse Mode
1) Because of slight physical differences between cassette shell
halves, cassettes recorded in the forward direction should be
played back in the forward direction to obtain the best results.
2) When recording, the direction of tape travel only switches
from forward to reverse. To keep track of which side is being
recorded so that you do not mistakenly use an already
recorded side, it is a good idea to always begin recordings
with side A.
This deck’s auto-reverse function automatically reverses the direc-
tion of tape travel in the playback or recording modes when the
end of the magnetic tape is reached. Tape travel is reversed as
soon as a photo sensor detects the presence of the clear leader at
the end of the tape. In other words, as soon as the sensor's light
ray passes through the tape, the direction of tape travel reverses.
Reversal takes place extremely quickly so the gap between sides
during playback is barely noticeable. If the cassette tape does not
have a clear Jeader section, tape travel is reversed the instant the
end of the tape (including the leader) is reached.
Auto-reverse may be activated prematurely with defective cas-
sette tapes with pin holes or other damage which allows fight to
pass through the tape. To prevent this from happening, play and
record such tapes using the "one side" tape transport mode in
which auto-reverse is not activated.

Onkyo K-200R Specifications

General

Brand	Onkyo
Model	K-200R
Category	Tape Deck
Language	English