En-8
■
Aiming the remote controller
Before using the remote controller, please remove
a plastic shield at battery holder.
Plastic shield
To use the remote controller, point it at the
sound bar’s remote control sensor, as shown
below.
5 m
5 m
■
Battery installation
This product contains a CR coin lithium battery.
1
While pushing the locking tab towards
the center of the remote controller,
slide out the battery holder.
Locking tab
Back of remote controller
2
Remove the old battery from the
battery holder, insert the new battery
and then slide the battery holder back
into the remote controller.
Positive (+) side
up
Precautions for battery use
Remove the battery if the sound bar will not be
used for a long period of time. This will prevent
pontential damage due to battery leakage such
as fire, injury or contamination of a surrounding
environment.
•
Do not use rechargeable battery (nickel-
cadmium battery, etc.).
•
Danger of explosion if battery is incorrectly
replaced.
•
Use only specified batteries.
•
Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such as
sunshine, fire or the like.
•
Installing the battery incorrectly may cause the
sound bar to malfunction.
Note
•
Replace the battery if the operating distance
is reduced or if the operation becomes erratic.
Purchase “CR2025”, coin lithium battery.
•
Periodically clean the transmitter on the remote
controller and the sensor on the sound bar with
a soft cloth.
•
Exposing the sensor on the sound bar to strong
light may interfere with operation. Change the
lighting or the direction of the sound bar if this
occurs.
•
Keep the remote controller away from moisture,
heat, shock and vibrations.
To Next Page
Loading...
Need help?
General
