En-30
Zone 2—Continued
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the receiver
1
To turn on Zone 2 and select an input
source, press the [ZONE 2] button
repeatedly.
Alternatively, press the [ZONE 2] button
followed by an INPUT selector within 8
seconds.
Zone 2 turns on and the Z2 (ZONE 2) indicator
appears.
To select the same source as that of the main room,
press the [ZONE 2] button repeatedly until “Zone 2
Selector: Source” appears.
Rotate the INPUT selector to select AM or FM.
Note:
You cannot select different AM or FM radio
stations for your main room and Zone 2. The same
AM/FM radio station will be heard in each room.
2
To turn off Zone 2, press the Zone 2 [OFF]
button.
Notes:
• Only analog input sources are output by Zone 2.
Digital input sources are not output. If no sound is
heard when an input source is selected, check to make
sure it’s connected to an analog input.
• While Zone 2 is on, the Auto Power On/Standby and
Direct Change RI functions do not work.
Controlling Zone 2 with the Remote
Controller
Note:
To control Zone 2, you must press the remote
controller’s [ZONE 2] button first.
1
Press the [ZONE 2] button, then point the
remote controller at the receiver and press
the [ON/STANDBY] button.
Zone 2 turns on and t
he Z2 (ZONE 2)
indicator
appears
.
2
To select an input source for Zone 2, press
the [ZONE 2] button, followed by an INPUT
SELECTOR button.
To select AM or FM press the [TUNER] Input
Selector button repeatedly.
Note:
You cannot select different AM or FM radio
stations for your main room and Zone 2. The same
AM/FM radio station will be heard in each room.
3
To turn off Zone 2, press the [ZONE 2] button,
followed by the [
ON/STANDBY] button.
Using Zone 2
To Next Page
Loading...
