Onkyo TX-8030 - Remote Controller

En-8
Getting to Know the Receiver—Continued
For detailed information, see the pages in parentheses.
a  button (11, 17, 30)
b INPUT SELECTOR buttons (17, 18, 21, 22, 30,
35, 36)
c MODE button (35, 36)
d Control buttons (35, 36)
e REPEAT button (35, 36)
f RANDOM button (35, 36)
g Arrow []/[]/[]/[] and ENTER buttons
(11, 22, 27, 29, 35, 36)
h SETUP button (11, 27, 29)
i CH/ALBUM buttons (24, 35, 36)
j VOLUME  / buttons (18, 31)
k Number buttons (23, 36)
l
>
10/D.TUN button (23)
m DISPLAY button (24, 35, 36)
n DIMMER button (19)
o REMOTE MODE buttons (8, 30, 31, 36)
p MENU button (36)
q RETURN button (27, 35, 36)
r AUDIO button (20)
s MUTING button (18, 31)
t CLR button (24)
u SLEEP button (19)
Remote Controller
a
e
b
d
h
i
k
m
l
g
c
f
n
j
u
t
s
r
q
p
o
Using the REMOTE MODE buttons
You can use this remote
controller’s Zone 2 capability to
control a Zone 2 device. To
control a Zone 2 device, start by
pressing the REMOTE MODE [ZONE 2] button.
After you’ve finished operating the Zone 2 device,
and would like to operate this receiver once again,
press the REMOTE MODE [MAIN] button.
If the expected operation does not occur even though
the remote controller is pointed toward the receiver, it
may be that Zone 2 is selected. Please press the
REMOTE MODE [MAIN] button. Once you’ve
pressed the REMOTE MODE [MAIN] button, there’s
no need to press this button again before each
operation; you can simply use the remote controller to
operate the receiver as usual. Similarly, once you’ve
pressed the REMOTE MODE [ZONE 2] button, you
can continue operating the Zone 2 device without
having to press this button again before each
operation.