To Next PageTo Next Page
Need help?Do you have a question about the Onkyo TX-NR545 and is the answer not in the manual?
General| Impedance | 16 Ω |
|---|---|
| Receiver type | Surround |
| Frequency range | 100 - 10000 Hz |
| Input sensitivity | 200 mV |
| Audio output channels | 7.2 channels |
| Signal-to-Noise Ratio (SNR) | 100 dB |
| Total Harmonic Distortion (THD) | 0.08 % |
| Dynamic power per channel (3 Ohm) | 160 W |
| Dynamic power per channel (4 Ohm) | 125 W |
| Dynamic power per channel (8 Ohm) | 85 W |
| Power output per channel (1KHz@6 Ohm) | 120 W |
| Power output per channel (20-20KHz@8 Ohm) | - W |
| HDMI in | 6 |
| Audio (L/R) in | 8 |
| Composite video in | 4 |
| Digital audio coaxial in | 1 |
| Component video (YPbPr/YCbCr) in | 2 |
| Connectivity technology | Wired & Wireless |
| Speakers connectivity type | - |
| Audio formats supported | AAC, FLAC, LPCM, MP3, OGG, WAV, WMA |
| Ethernet LAN | Yes |
| Bluetooth version | 2.1+EDR |
| Bluetooth profiles | A2DP, AVRCP |
| AM band range | 522 - 1611 kHz |
| FM band range | 87.5 - 108 MHz |
| Supported radio bands | AM, FM |
| Preset stations quantity | 40 |
| Internet radio services supported | Spotify, TuneIn |
| Optical drive included | No |
| Product color | Silver |
| Audio decoders | Dolby TrueHD, DTS-HD Master Audio |
| Damping factor | 60 |
| AC input voltage | 220-240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (standby) | 0.15 W |
| Power consumption (typical) | 430 W |
| Package weight | 11500 g |
Weight and Dimensions| Depth | 329 mm |
|---|---|
| Width | 435 mm |
| Height | 173.5 mm |
| Weight | 8600 g |
Step-by-step guide to reset the AV receiver unit to its default state.
Description of unit behavior when abnormal conditions are detected.
Details on how the self-diagnostic function operates.
Information on how diagnostic results are displayed on the unit's FL tube.
Steps for confirming protect cause and clearing diagnostic information.
Instructions for checking firmware versions and preparing for updates.
Detailed steps for updating firmware via USB in service mode.
Identifies PCBs related to no sound from HDMI input.
Identifies PCBs related to no sound from optical input.
Identifies PCBs related to no sound from analog input.
Block diagram illustrating the audio signal path and processing.
Block diagram illustrating the video signal path and processing.
Block diagram detailing digital audio signal flow.
Schematic diagram of the amplifier circuits.
Schematic detailing the voltage amplification stages of the amplifier.
Schematic diagram of the power supply unit.
Schematic diagram of the Microprocessor Unit.
Schematic for VMPU and related power supply circuits.
Schematic diagram of the HDMI interface and decoder circuitry.
Schematic diagram of the video processing unit.
Schematic showing ARM processor, DIR, and DAC connections.
Schematic diagram of the Digital Signal Processor.
Steps to enter various test modes for the unit.
Instructions for entering and using the audio debug mode.
Procedure to enter and exit service information mode for status analysis.
