Onkyo TX-NR545 - Firmware Management; Firmware Version Check and Update Preparation

Firmware
5 4 3
2
1
6
D
C
A
B
D
C
A
B
5 4 3
2
1
6
How to check Firmware Version & Preparation of Update
TX-NR545/646/747
DTR-20.7/30.7/40.7
Step1 : [DISPLAY] + [ON/STANDBY] x 2
Main Firmware Version will appear on the main unit’s display.
Step2 : [TONE +]
NET Firmware Version will appear on the main unit’s display.
Step3 : [TONE +]
DSP Firmware Version will appear on the main unit’s display.
Step4 : [TONE +]
VIDEO Firmware Version will appear on the main unit’s display.
Step5 : [TONE +]
OSD Firmware Version will appear on the main unit’s display.
Step6 : [TONE +]
VS100 Firmware Version will appear on the main unit’s display.
( DTR-40.7 only )
[Preparation of Update]
1. Connect the USB storage device to your PC. If there is any data in the USB storage device,
remove it.
2. Download the firmware file (package file) from the Onkyo FTP-server.
However European service partners should download the firmware file (package file) from
the ExtraNet.
Onkyo FTP-server: ftp://manex.onkyo.co.jp/_servicefwa/TX-NR545
ID and Password are those we informed when changed.
Filename is as follows: ONKAVR001D_****************.zip
Unzip the downloaded file. A following file is created.
ONKAVR001D_************.of1
ONKAVR001D_************.of2
ONKAVR001D_************.of3
ONKAVR001D_************.of4
ONKAVR001D_************.of5
3. Copy it to the USB storage device. Be careful not to copy the zip file.
4. Remove the USB storage device from your PC.