Need help?Do you have a question about the Onkyo TX-SR333 and is the answer not in the manual?
General| Output level | 100 mV |
|---|---|
| Receiver type | Surround |
| Frequency range | 5 - 100000 Hz |
| Input sensitivity | 200 mV |
| Audio output channels | 5.1 channels |
| Signal-to-Noise Ratio (SNR) | 100 dB |
| Total Harmonic Distortion (THD) | 0.7 % |
| Dynamic power per channel (3 Ohm) | 160 W |
| Dynamic power per channel (4 Ohm) | 125 W |
| Dynamic power per channel (8 Ohm) | 85 W |
| Power output per channel (1KHz@6 Ohm) | 100 W |
| Power output per channel (20-20KHz@8 Ohm) | - W |
| HDMI in | 6 |
| Composite video in | 4 |
| Digital audio coaxial in | 2 |
| Component video (YPbPr/YCbCr) in | 1 |
| Speakers connectivity type | RCA |
| Audio formats supported | AAC, FLAC, LPCM, MP3, OGG, WAV, WMA |
| Bluetooth | Yes |
| Ethernet LAN | No |
| Bluetooth version | 2.1+EDR |
| Bluetooth profiles | A2DP, AVRCP |
| RDS features | PS, PTY, RT, TP |
| AM band range | 522 - 1611 kHz |
| FM band range | 87.5 - 108 MHz |
| Supported radio bands | AM, FM |
| Preset stations quantity | 40 |
| 3D | - |
| Supported video modes | 1080p, 2160p |
| Product color | Silver |
| Audio decoders | Dolby TrueHD, DTS-HD, DTS-HD Master Audio |
| Damping factor | 60 |
| Center speaker impedance | 6 Ω |
| AC input voltage | 220-240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (standby) | 0.3 W |
| Power consumption (typical) | 330 W |
| Package weight | 10500 g |
| Package depth | 416 mm |
| Package width | 537 mm |
| Package height | 268 mm |
Weight and Dimensions| Depth | 321 mm |
|---|---|
| Width | 435 mm |
| Height | 150 mm |
| Weight | 8100 g |
Instructions for connecting the front left and right speakers to the unit.
Guidance on connecting the center speaker for dialogue clarity.
Details for connecting the surround left and right speakers for immersive sound.
How to connect a subwoofer with a built-in power amplifier for bass response.
How to set up speaker configuration (e.g., 5.1 ch) based on connected speakers.
Adjusting the distance from each speaker to the listening position for accurate sound.
Adjusting the volume level of individual speakers using test tones.
Configuring HDMI CEC (RIHD), HDMI Through, and ARC (Audio Return Channel) for seamless operation.
Steps for pairing and playing music wirelessly from a Bluetooth-enabled device.
Accessing and using the Quick Setup menu for input selection, audio settings, and speaker levels.
How to connect a separate room amplifier for multi-zone audio output using analog cables.
Steps to enable, control, and turn off the multi-zone playback feature.
Identifies all input/output jacks and terminals on the rear panel of the unit.
To Next Page
