Onkyo TX-SV424 - Unit Precautions and Accessories; Warranty and Copyright Information; Unit Care and Cleaning Guide; Power and Voltage Settings

Precautions
1. Warranty Card
The
serial
number
is
written
on
the
rear
panel
of
this
unit.
Copy
the
serial
number
and
model
number
onto
your
warranty
card
and
keep
it
in
a
safe
place.
2. Recording Copyright |
Recording
of
copyrighted
material
for
other
than
personal
use
is
illegal without permission of the copyright holder.
3. AC Fuse
The
fuse
is
located
inside
the
chassis
and
is
not
user-serviceable.
If
power
does
not
come
on,
contact
your
Onkyo
authorized
service
station.
4. Care
From
time
to
time
you
should
wipe
the
front
and
rear
panels
and
the
cabinet
with
a
soft
cloth.
For
heavier
dirt,
dampen
a
soft
cloth
in
a
weak
solution
of
mild
detergent
and
water,
wring
it
out
dry,
and
wipe
off
the
dirt.
Following
this,
dry
immediately
with
a
clean
cloth.
Do
not
use
rough
material,
thinners,
alcohol
or
other
chemi-
cal
solvents
or
cloths
since these
could
damage
the
finish
or
remove
the
panel
lettering.
5. Power
WARNING
BEFORE
PLUGGING
IN
THE
UNIT
FOR
THE
FIRST
TIME,
READ THE FOLLOWING SECTION CAREFULLY.
@
Some
models
are
designed
for
use
only
with
the
power
supply
voltage of the region where they are sold.
European and Australian models: AC 230V, 50Hz
U.S.A. and Canadian models: AC 120V, 60Hz
Worldwide model: AC 220V/120V switchable,
50/60Hz
e Voltage Selector (Rear Panel)
Worldwide
models
are
equipped
with
a
voltage
selector
to
con-
form to local power supplies. Be sure to set this switch to
match the voltage of the power supply in your area before
plugging
in
the
unit.
Models
without
a
voltage
selector
can
only
be
used
in
areas
where
the
power
supply
is
the
same
as
that of the unit.
The
power
does
not
shut
off
completely
by
just
turning
the
power
off.
So
power
cord
should
be
removed
from
AC
outlet
when
not
in
use for a prolonged time.
Supplied accessories
1 Remote control (RC-295S) 1 Remote control cable
2 Batteries (size AA, R6, or UM-3)
1 AM loop antenna
1 T-shaped FM antenna
The following accessories are only available
for worldwide models.
1 75/300 ohm antenna
adaptor
1 CV plug (Shape may vary
according to the area where
purchased.)
Setting
the
voltage
selector
and
tuning
step
frequency
(Worldwide
models
only)
VOLTAGE SELECTOR
covet 120V~
AM FREQ. STEP
QkHz ae OkHz
1, Determine the proper voltage for your
area: 220V or 120V.
2. If the preset voltage is not correct for
your area, insert a screwdriver into the
groove in the switch. Slide the switch
all the way to the right (120V) or to the
left (220V), whichever is appropriate.
Worldwide models are equipped with a
switch that controls the AM band tuning
steps. Please set this switch to match the
AM band tuning step frequency in your
area.
U.S.A. and Canada : 10kHz
Other areas : 9kKHz