Onyx RCR V2.0 - Key-Fob Button Layout; Power off to Standby; Power On;Off;Arm; Turn off Alarm + Power on

OPERATING CONTROLS
RCR MODEL
36
KEY-FOB BUTTON LAYOUT
POWER ON / OFF / ARM
Each bike comes equipped with two key fob
remotes that can turn on and o the main power
to standby, and set the alarm. Note this does not
fully kill the power to the system which allows for
the alarm and clock to function. Once the battery is
removed or turned o you will need to rst turn the
battery back on for the following to work correctly
again.
TURN OFF ALARM + POWER ON
1: Press the Unlock button once on the key fob and
a audible chirp should sound to conrm you have
activated the system. (C)
2: Press the Bolt button twice to turn on the sys-
tem. The dash, and running lights should illuminate
immediately following this step so long as the throt-
tle kill switch is in the on position. (D)
(Reference Function “Throttle Kill Switch On / O”)
POWER OFF TO STANDBY
1: Press the Unlock button once on the key fob and a au-
dible chirp should sound to conrm you have deactivated
the system. The dash, and running lights should turn o
following this step. (C)
ARMING THE ALARM
1: Make sure you have followed the steps to power o the
system to standby.
2: Press the Lock button once to set the alarm. (A)