MAINTENANCE
BASIC MAINTENANCE
CLEANING
Regularly clean and lubricate all moving parts, tight-
en nuts/bolts, and adjust as required. This includes
all steering parts, bicycle pedals, suspension, and
wheel parts. See the RCR HARDWARE AND TORQUE
SPECS document for hardware and tightening infor-
mation for your ONYX Motorbike.
PARTS + FAIRINGS SERVICE
REMOVING SIDE BODY PANELS
REMOVING THE SEAT
REMOVING THE HANDLEBARS
REPLACING BATTERY COVER LOCK
CHECK YOUR NUTS + BOLTS
With any moving vehicle it is good practice to always
check your hardware before you ride. You can do a visual
by doing a full walk around the bike before every ride
and you should do a physical check after every couple
rides to make sure nothing is vibrating loose. Most bikes
that encounter rough terraign will need attention more
often.
HARDWARE DESCRIPTIONS
TORQUE SPECS
CHECK YOUR ELECTRICAL
CHECK THE CONDITIONS OF YOUR WIRES
Inspect all wires for sheathing wear and loose connections.
CHECK ELECTRONIC COMPONENTS
Inspect all electronic components in on the bike and under
the battery cover for functionality.
ALARM KEY FOB BATTERY REPLACEMENT
Using a ne tip at head screw driver pop the two chrome
sides o, starting from the top of the remote. When those
are o starting from the bottom work your way around
the outside and the calm shell will open. The fob takes a
CR2032 battery.
MOTOR PHASE WIRE CABLE TIE
Inspect the zip ties that secure the phase wires from the
hub motor to the swingarm.
BATTERY AND CHARGER MAINTENANCE
BAT TERY
BATTERY CHARGER
REPLACING THE BATTERY CHARGER FUSE
RCR MODEL
52
To Next Page
Loading...
Need help?
General
