RCR MODEL
46
1. Prop the bike on its kickstand.
2. Remove the wood cover to turn on the battery
then replace the cover.
(SEE BATTERY COVER REMOVAL)
3. Use the key-fob to activate the bike’s power.
4. Press the kill switch on the throttle to power up
the system.
OPERATING INSTRUCTIONS
GENERAL OPERATION
THROTTLE
The speed of the bike is controlled with a twist grip
on the right side of the handlebar. To accelerate
twist the throttle towards you very slowly; to decel-
erate release slowly. Read the Pro-Tip in this section
about staying above 60 volts when you throttle.
BRAKING
To slow down, release the throttle control and apply
equal pull to both brake levers. Application of both
brakes at the same time is essential to prevent pre-
mature brake wear and/or loss of vehicle control.
CAUTION: Be alert when riding on wet or sandy
surfaces. Loss of traction between tire and road
can occur under these conditions. Be careful when
braking, turning, or accelerating under adverse
conditions.
To Next Page
Loading...
