Select The Active SIM (Manual Failover Mode)
Switching the active SIM must be done manually. To switch the Active SIM:
1. Navigate to CONFIGURE > NETWORKCONNECTIONS > Network Interfaces >
Cellular Interface (LTE.
2. Click the Settings cog , this will display the MANAGE CELLULAR INTERFACE
(LTE) page and the current status of both SIM slots, including the current carrier name.
3. On the right, select the Make Active button of the new, active SIM and apply the
change by selecting Confirm.
4. A pop-up alert states that this operation will take a few minutes to complete. Click Yes
to confirm the change.
Note: During the change-over the current IP address is hidden and then
returned when the modem re-connects.
5. If you require, you can monitor the interface during the changeover via the CLI with the
command:.
watch ip address show dev wwan0
CONFIGURE MENU 67
To Next Page
Loading...
Need help?
General