Opengear OM1208-8E User Manual

Disable a Root User
CONFIGURE > User management > Local Users
To disable a root user:
Note: Before proceeding, make sure that another user exists that has the
Administrator role or is in a group with the Administrator role. For information
on creating, editing, and deleting users, see "Local Users" on page77
1. Navigate to CONFIGURE > User management > Local Users
2. Click the Disable User button in the Actions section next to the root user.
3. Click Yes in the Confirmation dialog.
To enable root user, log in with another user that has the Administrator role and
click the Enable User button in the Actions section next to the root user.
.
Change Network Settings
CONFIGURE > Network Connections > Network Interfaces
The interface supports both IPv4 and IPv6 networks. The IP address of the unit can
be setup for Static or DHCP. The following settings can be configured for network
ports:
l IPv4, IPv6
l Static and/or DHCP
l Enabling or disabling network interfaces
l Ethernet Media types
To add a new connection:
INITIAL SYSTEM CONFIGURATION 22

Opengear OM1208-8E Specifications

General

Brand	Opengear
Model	OM1208-8E
Category	Switch
Language	English