EasyManua.ls Logo

OPTICLIMATE SPLIT PRO3 Series - Options, to be delivered with; Vibration Isolator Springs; Damping Plates; Condensation Drain Pump

OPTICLIMATE SPLIT PRO3 Series
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
Error 14 = Voltage interruption alarm.
The unit has come to be without tension. Through this alarm which occurs only in the alarm history at
the bottom of the screen is to see whether there is a stress problem.
Error 15 = High room temperature protection is active.
Only when the room temperature drops below the set temperature in cooling mode the unit will
heat sources, turn it on and the alarm will disappear. There remains a 15 in the log at the bottom of
the display. These can be deleted by holding down the (R) button and corresponding key.
Error 16 = Outside air temperature (for outdoor unit) to high 40 ° C.
Make sure the cooler air is drawn from the outdoor unit.
Error 17 = AI05 temperature sensor defective or not connected (no login)
Error 18 = Temperature AI06 defective or not connected (no login)
Error 19 = Temperature AI07 defective or not connected (no login)
Error 20 = AI08 temperature sensor defective or not connected (no login)
Options, to be delivered with
Vibration isolator springs
Vibration dampers for extra quiet room. These dampers are exactly calculated on the weight of the
unit and ensure almost 100% contact isolation.
This insulation is unattainable with other solutions from a hardware store.
Damping Plate with adhesive layer (2 pieces)
Anti-vibration plates; damping plates for quiet room. These plates can be placed on the flat panels
of the unit also stuck to keep radiated noise to the minimum.
Fuel pump for condensation
Head up to 4 meters. This pump is often used when there is no drainage close to the condensation
or if the unit is placed as the outlet is lower.
Connection PVC hose 6 mm. Standard with 5 meter hose.
3-way valve
Comes with servo motor and extra temperature of 10 meters. This valve makes it possible to cool
when the Dual Room function is enabled. 2 rooms 12/12
Each space has a sensor, and the sensors tracking the area where the cooling is active. The high
temperature protection will be active simultaneously for both spaces.
Plenum
This box can be placed on the back of the unit so OptiClimate outer space can be placed. The
plenum 1 to 3 hoses can be connected to suck the warm air from the room. Dimension suction hoses
are always greater where possible.
Carbon filters (3 pieces)
See Inspection and Maintenance

Related product manuals