5
The unit should be mounted so that the side of the condensation drain is sloping at least 1 cm lower
than the other side to make sure that the condensation flows out well. In practice, increases of 1 cm
on all angles, except for the corner of the electrical compartment, will enable the correct outcome.
The use of a spirit level is hereby advisable.
To avoid noises caused by vibration whilst in use, the OptiClimate comes with rubber mounts which
are suitable for pendant mounting.
For ground mounting or areas where it needs to be quiet you can remove the rubber mounts and
replace them with the isolator springs, which absorb more vibration. The unit will automatically fall to
the condensate drain.
Rubber Mounts Isolator Spring Mounts
To Next Page
Loading...
