Opticon NLV-5201 - Read, Trigger, and Buzzer Default Settings; Interface Communication Default Settings; RS-232 C Default Settings; USB Default Settings

NLV-5201 Specifications Manual
46
20.2 Read, Trigger, and Buzzer Default Settings
Parameter
Default Setting
Read Mode
Single read
Read Effective Time
Trigger synchronized
Buzzer Duration
100 ms
Good Read Buzzer Tone
3000 Hz
Start-Up Buzzer
Enable
Buzzer Loudness
Maximum
Buzzer Timing
Before data transmission
Good Read Indicator Color
Green
Good Read LED Indicator Duration
200 ms
Data Buffering*
Buffered mode
* Data buffering transfers the next piece of data that is read during the read data transfering process. Depending on
the host system, output data may be lost.
20.3 Interface Communication Default Settings
20.3.1 RS-232C Default Settings
Parameter
Default Setting
Baud Rate
9600 bps
Parity Bits
No parity
Data Bits
8 bits
Stop Bits
1 bit
Handshaking
No handshake
ACK/NAK
Disabled
CTS Time Out
Indefinitely
ACK/NAK Time Out
1 second
Command Header
ESC or STX
Command Terminator
CR or ETX
Response to Commands
Disabled
20.3.2 USB Default Settings
Parameter
Default Setting
Keyboard Language
USA (USB-HID)
Send “new line key “after data
Enabled
Send “TAB key” after data
Disabled
Send “→ key” after data
Disabled
Other
CDC-ACM compliant (USB-COM)*
* To use USB-COM, you need to install the latest version of the Opticon USB-COM driver on your host device.