5.2 Apple iPhone/iPad support
When iPhone/iPad mode is enabled it’s possible to toggle the iOS onscreen keyboard and use the trigger key to wake
up the iPhone/iPad from standby. It is recommended to disable the passcode lock option to prevent barcodes from
being entered as a passcode when waking up from standby.
_+-IOSON-+_
Enable iPhone/iPad mode
_+-IOSOFF-+_
Disable iPhone/iPad mode
Read one of the labels above to enable/disable iOS compatibility.
5.3 Memorizing
This application supports memorizing of barcodes in case the Bluetooth companion scanner loses its connection with
a remote Bluetooth device. This will allow barcodes scanned to be saved in in memory and be transmitted when a
connection is re-established.
See Section 2.3.8 of the Universal Menu Book or go to http://opticonfigure.opticon.com/ (Interface > Bluetooth
options > Memorizing) for all available options
5.4 Other Features
The Bluetooth companion scanner will show a yellow/orange LED 10 times for 1 minute when the battery is too low
for normal operation. After this, the device will shut off automatically. If this indicator is seen, it is imperative that
the device be attached to USB to charge the battery.
The current battery percentage level can be checked by sending the following serially:
<ESC>]BATT<CR>
When the device is in Bluetooth VCP or USB-VCP mode. In HID mode, the following codes can be scanned:
_ZZ_
_BATT_
_ZZ_
To Next Page
Loading...
Need help?
General
