EasyManuals Logo

Opticon OPN-2005 User Manual

Opticon OPN-2005
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Bluetooth Application Quick Setup - Guide
13
5 Universal Menu Book support
The Bluetooth companion scanner support the reading of various configuration options that can be found in the
Universal Menu Book. This makes it possible to customize the behaviour of the embedded application without
having to actually change the source code of the application.
The Bluetooth companion scanner support the menu options listed in the following chapters:
1. Defaults (See chapter 'Supported defaults' at the start of this set-up guide)
2.3. Bluetooth options (See 'Supported Bluetooth features' below)
3.1 Enabling/disabling readable codes
3.2 Setting of fixed, minimum and maximum lengths
3.3 Code specific options (almost all options are supported except some 2D decoder options)
4.1 Case conversion
4.2 Set prefixes
4.3 Set suffixes
5.1 Read modes, add-on wait modes
5.1.1 Multiple read reset time
5.1.2 Quite zone options (margins)
5.2. Read time options
5.4 Redundancy
5.5 Positive and negative barcodes
6.1 Buzzer settings
6.2 Good read LED
7.1 Diagnostics
7.2 Enabling / disabling configuring via serial commands
All listed options are also available at http://opticonfigure.opticon.com/
5.1 Supported Bluetooth features
In the Opticon Universal Menu Book there are additional Bluetooth features listed for Opticon barcode readers with
Bluetooth support. Some of these features are also available in this application.
The following of these listed features are supported:
Chapter 2.3.1: Bluetooth connection labels
+-CONN-+ (Manually connect label)
+-DISC-+ (Manually disconnect label)
+-DSCO-+ (Make discoverable / connectable)
Chapter 2.3.2: Bluetooth security (Authentication / encryption)
Chapter 2.3.3: Configurable Trigger-to-connect time (default = 3 seconds)
Chapter 2.3.4: Configurable Trigger-to-disconnect time (default = 5 seconds)
Chapter 2.3.6: Auto reconnect options (default = 1 minute)
Chapter 2.3.7: Wireless power saving options
Chapter 2.3.8: Memorizing
See also http://opticonfigure.opticon.com/ (Interface > Bluetooth options)

Other manuals for Opticon OPN-2005

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Opticon OPN-2005 and is the answer not in the manual?

Opticon OPN-2005 Specifications

General IconGeneral
BrandOpticon
ModelOPN-2005
CategoryData Loggers
LanguageEnglish

Related product manuals