10 11
Installation
After the end of scanning use OK button and then the receiver will display
the rst scanned channel.
Use OK button on remote control to display channel list. Using / but-
tons choose a channel You want to watch and conrm your choice using
OK button.
2.3 First Scan 2.4 Automatic Power Down
2.5 Working with External USB Drive
2.6 Antenna Power Supply
After the conguration, use the blue button or OK on remote control to start
scanning TV and radio channels. It will not happen if your antenna is not con-
nected and properly congured.
In accordance with actual European Union requirements, your receiver is
equipped with function “Automatic Power O”. It works by switching the
receiver into standby mode after a period of 3 hours after the last active use.
In practice this means that if during this time the receiver will not be given
any command by using the remote control or keypad on the front panel,
the receiver turns o. Turning o the receiver will be preceded (2 minutes
previous) by a relevant message on the TV screen. Please also note that this
feature is enabled by default, but at your own request, you can disable it
using the appropriate functions in the receiver menu.
During the selection and operation with USB drive (HDD, ash drive), You
should pay attention to the following issues:
1. Drive is compatible with USB 2.0 and has appropriate write and read speed,
2. Drive contains one single partition, formatted in supported format,
3. If necessary, drive should be supplied from an external power supply
(especially for USB hard drives),
4. Do not disconnect the drive during a write/read data operation,
5. Do not use full or fragmented drive.
plug USB drive in here
If your antenna needs a +5V power supply - use MENU button to enter
the main menu and using / buttons enter Installation menu, select
Channel Scan and set Tuner Power ON and exit using MENU button. Next,
using cursor buttons select Auto Scan to scan all available channels.
To Next Page
Loading...
Need help?
General
