Opticum Dekoder STB User Manual

26 27
Menu
New Password Use the 0–9 buttons to enter your new password
(4 digits) here.
Conrm Password Re-enter your password here to conrm.
OSD Setting
This menu allows you to change settings for OSD appearance and more. Use
/ to select OSD Setting and press OK to proceed.
Subtitle Display Use / to toggle between On or O. Set to
On if you want to see subtitles on the screen.
OSD Timeout Use / to set the time after which on screen
banners and messages disappear. The range
is 1–10 seconds.
Menu Style Use / to change color of OSD.
OSD Transparency Use / to set the OSD transparency from
O to 40% with 10% steps.
Volume step Use / to toggle between x1 or x2 to set
the step for changing volume.
Load default OSD settings Press OK to clear all OSD settings and reset to
default values.
Auto Standby
Auto Standby is a new feature that helps you with reducing power consump-
tion. See chapter Automatic Power Down (p. 11) for details.
Auto Standby Use / to toggle between On or O. When set
to On, the receiver will turn to standby if it doesn’t
receive any commands from the remote control
for three hours. Set Auto Standby to O to avoid
the automatic shut down.
Turn on after blackout Use / to toggle between On or O. Set to On
if you want the receiver to automatically turn on
after a blackout.
4.5 Tools
Use / to select Tools and press OK or to enter. Use / to highlight the
desired submenu and press OK to select. Press EXIT or MENU to get back to
the main menu.
Information
This submenu shows receiver specic information such as hardware version
and software version. Please have the Information screen on hand when you
call our hotline. The person who answers your call might ask for the informa-
tion given in this screen.
Load Factory Settings
This option allows you to reset the receiver to factory settings, which clears
all your settings and stored channels. It will restore your receiver to an “out
of the box” state. Use / to select Load Factory Setting in the Tools menu
and press OK. You are asked to input password. Input the correct password
using the 0–9 buttons (default password is: 0000). A conrmation window is
displayed. Select Yes to return to factory settings. Select No if you don’t want
to restore. Press EXIT to leave.
Upgrade by RS232
S/W upgrade by OTA
Upgrade by USB
This option is highly recommended to be used only by advanced users.
Upgrade by RS232 allows you to upgrade your receiver’s software via RS232
cable connected to your computer. You must use an external converter to
connect RS232 to SCART connector. Use / to select Upgrade by RS232
and press OK. Select START and press OK or to start upgrading. Press EXIT
to leave.
This receiver is equipped with an Over The Air software upgrade option. An
Over The Air update might not be available in your region. Please contact
your local service hotline for more information about this option. Use / to
select S/W upgrade by OTA and press OK. Select START and press OK or to
start upgrading. Press EXIT to leave.
This feature allows you to upgrade your receiver’s software via the USB port.
If new software is available for your receiver, it can be downloaded from our
website www.opticum.com.pl.
Place the software le (unzipped) in the root directory of your USB storage
device (HDD, memory stick etc.) and insert this device into the USB port of
the receiver. Select Upgrade by USB from the Tools menu and press OK to
proceed. The upgrade menu will now be displayed.

Opticum Dekoder STB Specifications

General

Brand	Opticum
Model	Dekoder STB
Category	Media Converter
Language	English