Read and follow all instructions before use calibration, inspections, and maintenance should be
performed by professionals
Ensure the indicator rests on a stable surface
DO NOT disassemble or modify unity
DO NOT exceed the rated load limit of the unit
DO NOT step on the unit
DO NOT jump on the unit
DO NOT use this product if there are any signs of damage
DO NOT use for purposes other than weight taking
Avoid faulty readings before weighing samples with static electric charge by discharging them
or wiping the indicator with an anti-static agent
Electrical Safety
Unit must be connected to a GFCI outlet
Disconnect power before servicing unit
All operators MUST discharge themselves before servicing unit by touching a grounded
surface or by wearing a grounded anti-static wrist strap
Always pull the plug – not the cord – when disconnecting from the outlet
DO NOT use if the power cord is worn or damaged
Power cords should only be replaced by qualified service technicians using genuine
replacement parts
SAFETY PRECAUTIONS
PREPARATION & SET UP
If the indicator is powered by an adapter, plug the adapter directly into the “DC” pin located at
the bottom of the indicator.
Always use a wall outlet to avoid interference from other wires
Turn on the indicator when there is no load
Calibrate before weighing when the scale is initially installed or moved to a new location
- 1 -
To Next Page
Loading...