Power On
Turn on the power by pressing the power button for 2 seconds. Once on, the scale will ash the
voltage and then begin to auto-check and count down from 0-9 sequentially before entering the
weighing mode
Note: Anything on the scale before powering on will automatically be tared out.
Zeroing
The zero function is used only when the scale is empty and is not at gross zero due to material
build up
Pressing the ZERO key will reset your scale to 0
Depending on what your manual zero range parameter is set to, you can zero out any number
within your set selection, after that you will receive an error and will need to tare out the weight
Unit Selection
To switch between measuring units (kg/g) press the UNITS key
Tare Function
The Tare function is used when you only wish to see the current change in weight, not the entire
amount of weight that is on the scale
When the indicator is in gross mode (gross light is shown) pressing the TARE key will Tare the
current weight on the scale and enter the net mode (net light shown)
For example if you are using a container add the container to the scale, press tare and the display
will show the tare symbol and reset back to 0
Add your product to the scale to weigh without the weight of the container
To exit Tare mode press the TARE key again to enter gross mode and you will see the total weight
of the container and the product
REAR PANEL
LOAD CELL: Port for connecting load cell.
RS-232 PORT: Serial interface port. (computer, printer)
DC POWER: Port for DC power. (DC 12V adapter are available)
LOAD CELL
RS-232 PORT DC POWER
OPERATING INSTRUCTIONS
- 5 -
To Next Page
Loading...
