Optimum 600M - OPERATION INSTRUCTION; Juicer Operation and Controls; Handling Operational Issues

6 // OPTIMUM 600M
OPERATION INSTRUCTION
1. Insert the plug into the socket (make sure the socket has reliable grounding), turn on the control
button.
ON
OFF
REV
ON: Activates the motor and starts making
juice.
OFF: Stops the operation. Center the button to
turn o the product.
REV: Activates the reverse operation. Flip
the button to REV to dislodge ingredients if
something gets stuck in the device.
2. Wash all fruits and vegetables
3. After washing and cutting, slowly add prepared ingredients into the machine. If necessary, use the
pusher to ensure all ingredients are fully inserted in the device. Remember to remove any hard
seeds from ingredients before juicing.
Note:
A) The ingredients should be put into the device one by one. When you’ve successfully inserted
one ingredient, you may proceed with adding the next. It is recommended to size all ingredients
to approximately 10x3x2cm.
B) Hard-fiber ingredients (such as celery) should be cut into properly sized portions. It is
recommended to size such ingredients to approximately 5-10cm in length.
C) Fiber-poor ingredients (such as carrots) are preferred to be extracted alongside fiber-rich
ingredients like celery. Simply cut the carrots into four equal parts. Due to dierences in the
moisture content of your ingredients, you will notice variations in the extracted juice amounts.
D) Stale ingredients will produce the least amount of juice. Ingredients that have been refrigerated
for extended periods of time should be soaked in pure water to rehydrate before extraction.
E) Ingredients will respond dierently to the juicing process. For the best results, do not exceed the
outlined maximum levels in the juicing bowl. If the bowl becomes overfilled, your juice and pulp
will have diculty exiting the device. As a result, the device may begin to leak from the mouth of
the bowl or through shaft seal, creating spillage. This is especially true when juicing ingredients
such as cucumber, cherries, or tomatoes.
F) Notice: Do not attempt to dislodge or insert ingredients using foreign objects such as chopsticks
or spoons. If necessary, you may use the pushing bar to guide ingredients into the juicer.
4. If the machine suddenly stops, first, turn the power button to the OFF position. Then, shift the power
button to the REV position, to dislodge jammed ingredients. When the ingredients have shifted back
between the strainer/auger and bowl, you may return the power button to the ON position.
Note: If the above operation does not correct the issue, follow the instructions in this guide to
disassemble the device. Then, follow the instructions for cleaning the bowl before attempting to reuse
the juicer.
Note: Always place the power button in the OFF position before applying the REV function. Wait until the
machine has fully stopped, then switch the power button to REV.
5. Turn o the machine after juicing.