Optimum OPTImill BF 16 Vario - Default Chapter; Table of Contents

To Next Page

To Previous Page

Version 1.4.3 - 2020-12-142 Translation of original instruction

BF16V

BF16V_GBIVZ.fm

Table of contents

1 Safety

1.1 Type plate...................................................................................................................................................... 5

1.2 Safety instructions (warning notes)................................................................................................................ 6

1.2.1 Classification of hazards.................................................................................................................. 6

1.2.2 Other pictograms.............................................................................................................................. 6

1.3 Intended use.................................................................................................................................................. 7

1.4 Reasonably foreseeable misuses.................................................................................................................. 8

1.4.1 Avoiding misuses ............................................................................................................................. 8

1.5 Possible dangers caused by the drilling-milling machine .............................................................................. 9

1.6 Qualification................................................................................................................................................... 9

1.6.1 Target group private users............................................................................................................... 9

1.6.2 Obligations of the User................................................................................................................... 10

1.6.3 Additional requirements regarding the qualification ....................................................................... 10

1.7 Operator positions ....................................................................................................................................... 10

1.8 Safety measures during operation............................................................................................................... 10

1.9 Safety devices ............................................................................................................................................. 10

1.9.1 EMERGENCY-STOP button......................................................................................................... 11

1.9.2 Protective cover ............................................................................................................................. 11

1.9.3 Milling chuck protection.................................................................................................................. 12

1.10 Safety check ................................................................................................................................................ 12

1.11 Personnel protective equipment .................................................................................................................. 12

1.12 For your own safety during operation .......................................................................................................... 13

1.13 Switching-off and securing the drilling-milling machine ............................................................................... 13

1.14 Using lifting equipment ................................................................................................................................ 13

1.15 Signs on the drilling-milling machine ........................................................................................................... 14

1.16 Electronics ................................................................................................................................................... 14

2 Technical data

2.1 Electrical connection.................................................................................................................................... 15

2.2 Drilling-milling capacity ................................................................................................................................ 15

2.3 Spindle seat................................................................................................................................................. 15

2.4 Drill-Mill head............................................................................................................................................... 15

2.5 Cross table................................................................................................................................................... 15

2.6 Dimensions.................................................................................................................................................. 15

2.7 Working area ............................................................................................................................................... 15

2.11 Emissions .................................................................................................................................................... 16

2.8 Speeds......................................................................................................................................................... 16

2.9 Environmental conditions............................................................................................................................. 16

2.10 Operating material ....................................................................................................................................... 16

2.12 Installation plan BF 16V............................................................................................................................... 17

2.13 Installation plan of optional substructure ..................................................................................................... 18

3 Delivery, interdepartmental transport and unpacking

3.1 Notes on transport, installation and unpacking............................................................................................ 19

3.1.1 General risks during internal transport........................................................................................... 19

3.2 Scope of delivery ......................................................................................................................................... 20

3.3 Installation and assembly ............................................................................................................................ 20

3.3.1 Requirements regarding the installation site.................................................................................. 20

3.3.2 Load suspension point ................................................................................................................... 20

3.3.3 Assembly........................................................................................................................................ 21

3.4 First commissioning..................................................................................................................................... 21

3.4.1 Power supply.................................................................................................................................. 21

3.4.2 Cleaning and lubricating................................................................................................................. 21

3.4.3 Warming up the machine ............................................................................................................... 22

4Operation

4.1 Control and indicating elements .................................................................................................................. 23

4.2 Safety........................................................................................................................................................... 24

4.3 Switching on the drilling-milling machine..................................................................................................... 24

4.4 Inserting a tool ............................................................................................................................................. 24

4.4.1 Use of collet chucks ....................................................................................................................... 25