11
... English
Installation
Power/Standby
Powering On the Projector
1. Remove the lens cap.
2. Ensure that the power cord and signal cable are securely
connected. The Power LED will flash green.
3. Turn on the lamp by pressing “Power/Standby” button on
the control panel.n And the Power LED will turn green.
First time use the projector, you can select your prefered
language from quick menu after the startup screen display.
4. Turn on your source (computer, notebook, video player ,etc.).
The projector will detect your source automatically.
If the screen displays “No Signal”, please make sure the signal
cables are securely connected.
If you connect multiple sources at the same time, use the “Source”
button on the control panel to switch.
Powering On/Off the Projector
Turn on the
projector first and then
the signal sources.
1
Quick Menu
Select language
Press Enter to Set
To Next Page
Loading...
