Please note that
damage resulting
from incorrect
installation will
invalidate the
warranty.
To prevent damage to your projector, please use the Optoma ceil-1.
ing mount.
If you wish to use a third party ceiling mount kit, please ensure the 2.
screws used to attached a mount to the projector met the follow-
ing specications:
Screw type: M4*3 `
Maximum screw length: 10mm `
Minimum screw length: 7.5mm `
Warning:
1. If you buy a ceiling mount from another company, please
be sure to use the correct screw size. Screw size will vary
depending on the thickness of the mounting plate.
2. Be sure to keep at least 10cm gap between the ceiling and
the bottom of the projector.
3. Avoid installing the projector near a heat source.
To Next Page
Loading...
