13
• The BE Live5 will prioritize the audio from Primary device.
• You can control Primary device using the BE Live5 in line controller.
• When Primary device is idle, your BE Live5 can receive audio from
Secondary device.
• Secondary device must be controlled directly from its operating
system.
• Simultaneous audio from both devices is disabled.
Restore Factory Settings
When you restore the BE Live5 to its factory settings, the paired devices
stored will be deleted.
To restore factory settings:
1 Ensure that your BE Live5 are not connected to any device.
2 Put the BE Live5 in pairing mode.
3 Press simultaneously the Power/Function, Volume Up, and Volume
Down buttons for 2 seconds until the LED indicator flashes red five times
and you hear five short tones from the BE Live5.
Because all pairing information is deleted after restoring factory settings,
the BE Live5 will directly enter pairing mode once powered on.
Voice Prompts list
The BE Live5 are pre-loaded with English voice prompts
“Power On”
“Power Off”
“Full Battery”
“Battery at 50%”
“Battery Low”
“Primary device connected”
“Secondary device connected”
“Pairing Mode Activated”
“Voice Dial”
To Next Page
Loading...
