Optoma NuForce Bluetooth BE Live5 User Manual

7
Bluetooth Pairing
Using your BE Live5 for first time
Pairing BE Live5 with source device
1. Press and hold the BE Live5’s Power/Function button for 4
seconds until the LED indicator light flashes blue/red. Your BE Live5
is now in pairing mode.
2. Turn on Bluetooth® on your source device, then select “Optoma
NuForce BE Live5” once it appears on the device list.
NOTE: Consult your source device’s user manual for instructions on activating
Bluetooth.
3. Once successfully paired, the LED indicator will flash blue and
you hear “Primary device connected” (when voice prompt enabled)
from your BE Live5, or a beep if voice prompt is not enabled.
Please note:
A. You must always enter “Pair” mode from a powered-off state.
1
2
3

Optoma NuForce Bluetooth BE Live5 Specifications

Connectivity

connection type	Bluetooth 2.4Ghz
Bluetooth type	V4.1
Bluetooth profile	HSP 1.2, HFP 1.6, A2DP 1.2, AVRCP 1.4
A2DP Codec	SBC, Qualcomm® aptX™ audio, AAC

Audio

driver type	Dynamic
driver size	8 mm
impedance	16 Ohm
frequency response	20Hz - 20kHz
sensitivity	99dB +/-3dB at 1KHz

Battery

battery life	Up to 8 hours
battery type	Lithium-ion battery, Cylindrical Type, Typical 3.7V/55mAh x2 pcs
power consumption	15mA at A2DP mode

Operating Environment

microphone sensitivity	-42 +/-3 dB
operation temperature	0-45 degrees Celsius

Weight and Dimensions

cable length	580 +/- 20 mm
weight	16 Grams
range	Up to 10m