Display Modes
The Acme Packet 6300/6350 graphic display defaults to one of two display modes:
• Base display is the default and indicates a properly-functioning Acme Packet
6300/6350.
• Alarm mode becomes the default display mode when any alarms are active on the
Acme Packet 6300/6350. Active fault information is continuously displayed on the
graphic display.
Base Display
The base display shows the type of Acme Packet 6300/6350 running. This information
appears when the system first starts up and when the graphic display times out at any
menu level.
NET - NET
SESSION DIRECTOR
The base display of a Acme Packet 6300/6350 in an HA node includes additional
information applicable to its HA state. See the "Graphic Display Output for HA Nodes"
section in this chapter.
Alarm Display
The alarm display replaces the base display during an alarm condition. The alarm
display informs you of what symptoms are currently causing alarms. The number and
type of alarms appear on the Acme Packet 6300/6350 graphic display, which indicates
either a link alarm or a hardware alarm. For example, if there are two link alarms
present on the Acme Packet 6300/6350, the display appears like this:
2 LINK ALARMS
If the graphic display indicates an alarm condition, you can use the ACLI display-
alarms command to display the details of the alarm. When an alarm condition is
cleared, the base display replaces the alarm display. To clear an alarm, you must
execute the ACLI clear-alarm command or resolve the cause of the alarm.
Graphic Display Menus
The Acme Packet 6300/6350 graphic display lets you access the five display menus
for quick access to the system’s current status.
Top Menu
The top menu provides top-level access to information in distinct categories of system
functionality.
To access the top menu from the base display or alarm display:
1. Press the Enter button. The first entry in the top menu appears.
Chapter 3
Display Modes
3-2
To Next Page
Need help?
General
