INTERFACE Menu
The INTERFACE menu allows you to scroll through a list of all configured physical
interfaces. The management and media physical interfaces appear in the list, as does
the loopback interface.
The following information is displayed for each configured interface to which you scroll:
• Interface slot and port: interface status
• Input packets, output packets
• Input error packets, output error packets
Slot 1: Port0 UP
PKT IN: 1,001K OUT: 223K
ERR IN: 0 OUT: 0
To exit the INTERFACE menu in the graphic display:
1. From the top menu of the graphic display, press the Enter button.
2. Press the Up or Down button to scroll to the INTERFACE selection.
3. Press the Enter button.
4. Press the Up or Down button to scroll through the list of configured physical
interfaces.
5. Press the Enter button to refresh the display.
6. Press the Up or Down button to scroll to the RETURN selection.
7. Press the Enter button to return to the Top Menu.
BOOT PARAMS Menu
The BOOT PARAMS menu allows you to view the same information configured in
the bootparam ACLI configuration. The BOOT PARAMS selection displays the IP
information necessary to connect to the first Ethernet interface, eth0, located on the
left side on the back of the Acme Packet 6300/6350. This interface is used primarily for
maintenance, configuration, and downloading software images.
The following information for eth0 is displayed under the BOOT PARAMS menu:
• IP address
• Netmask
• Gateway IP address
inet: 192.168.0.2
mask: 255.255.255.0
gw: 192.168.0.1
To exit the BOOT PARAMS menu in the graphic display:
1. From the top menu of the graphic display, press the Enter button.
2. Press the Up or Down button to scroll to the BOOT PARAMS selection.
3. Press the Enter button. The BOOT PARAMS information is displayed.
Chapter 3
Graphic Display Menus
3-4
To Next Page
Loading...
Need help?
General
