1. Save any configuration changes you have made in the ACLI by typing save-
config Enter in Superuser mode.
ACMEPACKET# save-config
Save-Config received, processing.
waiting 1200 for request to finish
Request to 'SAVE-CONFIG' has Finished,
Save complete
Currently active and saved configurations do not match!
To sync & activate, run 'activate-config' or 'reboot activate'.
ACMEPACKET#
2. Execute the reboot command at the Superuser prompt by typing reboot and then
pressing Enter.
ACMEPACKET# reboot
-----------------------------------------
WARNING: you are about to reboot this SD!
-----------------------------------------
3. Type Y and then press Enter at the confirmation prompt to proceed with the
reboot.
Reboot this SD [y/n]?: y
System Reset
Resetting the Acme Packet 6300/6350 via the rest button on the front of the chassis
performs a cold reboot. This is the equivalent to disconnecting the power from the
system and then reconnecting it. There is no orderly termination of tasks, and the
system shuts down abruptly. You should only reset the Acme Packet 6300/6350 in
this way when it becomes unstable and there is no other possible means of gaining
administrative control.
During a system reset, certain files are not closed properly, and they may become
corrupted. Depending on what files become damaged, the system might become
completely unusable.
Note:
Always try to first reboot the Acme Packet 6300/6350 from the ACLI before
performing a cold reset. Only reset the system as a last resort.
To reset the Acme Packet 6300/6350:
• Insert a rigid paperclip-sized tool into the small hole on the front of the chassis
beneath the graphic display. The system immediately resets and begins its
initialization and boot sequence.
Chapter 6
Rebooting, Resetting, and Power Cycling
6-3
To Next Page
Loading...
Need help?
General
