Installing the Chassis Ears and Slides
In this second portion of system installation, two chassis ears and two chassis slides
are secured to the Acme Packet 6300/6350.
To install the chassis slide rails on the Acme Packet 6300/6350:
1. Locate the following components:
• 6 x 10-32 x 5/16” flat head (black) screws
• 2 x front mounting ears (left and right)
• 6 x 6-32 x 5/16” screws
• 2 x chassis slides
2. Line up one chassis ear with the tapped holes as shown in the following image.
Position the chassis ear’s spring-loaded thumbscrew toward the front panel of the
system.
Chassis Ear Mount Points
3. Use 3 x 10-32 x 5/16” Flat head screws to secure the chassis
ear to the chassis. Final installation resembles the image below.
Chassis Ear Installed
4. Line up the chassis slide with the Acme Packet 6300/6350 side panel. Position
the slide’s large marker hole at the front of the Acme Packet 6300/6350 chassis.
The remaining three tapped holes will line up with the slide’s holes. The following
image points out the tapped holes.
Chapter 4
Cabinet-Style 4-Post Chassis Installation
4-17
To Next Page
Loading...
Need help?
General
