Remove Power Distribution Board
Caution - Equipment damage. Remove all power from the system before removing or
installing the power distribution board. Power down both server nodes (also called system
controllers) and disconnect the power cords from the system before performing these
procedures. For instructions, see “Shutting Down a Server Node and Powering Off the
System” on page 143.
This section includes:
■
“Remove Power Distribution Board” on page 208
■
“Install Power Distribution Board” on page 210
Remove Power Distribution Board
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes removing the power distribution board from Oracle Database Appliance
Version 1.
1.
Prepare the system for service.
a.
Power off the system.
See “Shutting Down a Server Node and Powering Off the System” on page 143.
b.
Disconnect the power cords from the system.
c.
If the system is installed in a rack, remove it.
For information on racking the system chassis, see the Oracle Database Appliance
Owner's Guide.
d.
Remove both power supplies from the system.
See “Remove a Power Supply” on page 164.
e.
Attach an antistatic wrist strap.
See “Performing Electrostatic Discharge and Antistatic Prevention
Measures” on page 146.
208 Oracle Database Appliance Service Manual • November 2017
To Next Page
Loading...
Need help?
General