If you are installing new host adapters in your nodes, shut down and power o Node A.
For the procedure about how to shut down and power o a node, see your Oracle Solaris
Cluster system administration documentation. For a list of Oracle Solaris Cluster
documentation, see
“Related Documentation” on page 6.
Install the host adapters in Node A.
For the procedure about how to install host adapters, see the documentation that shipped with
your host adapters and nodes.
Cable the storage array or storage system to Node A.
For cabling diagrams, see
Appendix A, “Cabling Diagrams.”
Ensure that each device in the SCSI chain has a unique SCSI address.
To avoid SCSI-chain conicts, the following steps instruct you to reserve SCSI address 7 for one
host adapter in the SCSI chain and change the other host adapter's global scsi-initiator-id
to an available SCSI address. Then the steps instruct you to change the scsi-initiator-id for
local devices back to 7.
Note – A slot in the storage array might not be in use. However, do not set the
scsi-initiator-id to a SCSI address for that disk slot. This precaution minimizes future
complications if you install additional disk drives.
a. If necessary, power on the storage devices.
Note – If necessary, halt the nodes so that you can perform OpenBoot PROM (OBP) Monitor
tasks at the ok prompt.
For the procedure about powering on a storage device, see the service manual that shipped
with your storage device.
b. If necessary, power on a node, but do not allow it to boot. If necessary, halt the system to
continue with OBP Monitor tasks.
c. Set the scsi-initiator-id for one node to 6.
{1} ok setenv scsi-initiator-id 6
scsi-initiator-id = 6
d. Find the paths to the host adapters that connect to the local disk drives.
{0} ok show-disks
Use this information to change the SCSI addresses in the nvramrc script. Do not include the
/sd directories in the device paths.
6
7
8
9
Installing Storage Arrays
Oracle Solaris Cluster 3.3 With StorEdge A1000 Array, Netra st A1000 Array, or StorEdge A3500 System Manual
• May 2011, Revision A
18