e. Edit the nvramrc script to set the scsi-initiator-id for the local devices on the rst node
to 7.
For a full list of commands, see the
OpenBoot 2.x Command Reference Manual.
Caution – Insert exactly one space after the rst double quote and before
scsi-initiator-id.
{0} ok nvedit
0: probe-all
1: cd /pci@1f,4000/scsi@2
2: 7 encode-int " scsi-initiator-id" property
3: device-end
4: cd /pci@1f,4000/scsi@3
5: 7 encode-int " scsi-initiator-id" property
6: device-end
7: install-console
8: banner[Control C]
{0} ok
f. Store the changes.
The changes you make through the nvedit command are recorded on a temporary copy of
the nvramrc script. You can continue to edit this copy without risk. After you complete your
edits, save the changes. If you are not sure about the changes, discard them.
■
To store the changes, type the following command:
{0} ok nvstore
{1} ok
■
To discard the changes, type the following command:
{0} ok nvquit
{1} ok
g. Verify the contents of the nvramrc script that you created, as shown in the following
example.
If the contents of the nvramrc script are incorrect, use the nvedit command to make
corrections.
{0} ok printenv nvramrc
nvramrc = probe-all
cd /pci@1f,4000/scsi@2
7 " scsi-initiator-id" integer-property
device-end
cd /pci@1f,4000/scsi@3
7 " scsi-initiator-id" integer-property
device-end
install-console
banner
{1} ok
Installing Storage Arrays
Chapter 1 • Installing and Maintaining a SCSI RAID Storage Device 19
To Next Page
Loading...
