h. Instruct the OpenBoot PROM (OBP) Monitor to use the nvramrc script, as shown in the
following example.
{0} ok setenv use-nvramrc? true
use-nvramrc? = true
{1} ok
If you are not installing new host adapters in Node B,skiptoStep 13.
If you are installing new host adapters in Node B to connect Node B to the storage array or
storage system, shut down and power o the node.
For the procedure about how to shut down and power o a node, see your Oracle Solaris
Cluster system administration documentation. For a list of Oracle Solaris Cluster
documentation, see
“Related Documentation” on page 6.
Install the host adapters in Node B.
For the procedure about how to install host adapters, see the documentation that shipped with
your nodes.
Cable the storage array or storage system to Node B.
For cabling diagrams, see
“Adding a Sun StorEdge A3500 Storage System” on page 51.
If you did not power o Node B to install a host adapter, skip to
Step 17.
If you powered o Node B to install a host adapter, power on Node B and the storage array or
storage system.
Do not enable the node to boot. If necessary, halt the system to continue with OpenBoot PROM
(OBP) Monitor tasks.
Verify that Node B recognizes the new host adapters and disk drives.
If the node does not recognize the new hardware, check all hardware connections and repeat the
installation steps you performed in
Step 12.
{0} ok show-disks
...
b) /sbus@6,0/QLGC,isp@2,10000/sd...
d) /sbus@2,0/QLGC,isp@2,10000/sd...{0} ok
Verify that the scsi-initiator-id is set correctly on the second node.
a. If necessary, power on the second node, but do not allow it to boot. If necessary, halt the
system to continue with OBP Monitor tasks.
10
11
12
13
14
15
16
17
Installing Storage Arrays
Oracle Solaris Cluster 3.3 With StorEdge A1000 Array, Netra st A1000 Array, or StorEdge A3500 System Manual
• May 2011, Revision A
20
To Next Page
Loading...
Need help?
General