Hardware Issues
The following table lists the current hardware issues.
Hardware Issues Workaround
“System Posts CPU Fault and Fails to Boot On System With Six Sun InfiniBand Dual Port
4x QDR PCIe Low Profile Host Channel Adapter M2 Cards (22536804)” on page 32
Yes
“Reset Takes a Long Time and Causes the Server to Power Cycle” on page 32 N/A
“Update SP Firmware After Replacing a CMOD or SP Module (15465497)” on page 33 Yes
“MegaCLI CfgEachDskRaid0 Command Does Not Work Correctly (CR
7121867)” on page 33
Yes
“DIMM Mismatch on Odd Numbered Pairs Results in DDR Training Failed on Entire
Branch (CR7101624 and CR7111545)” on page 34
Yes
“If DIMM Failure Causes Branch Failure, Oracle ILOM Might Not Identify Them as Faulty
(CR7099038 and CR7111543)” on page 35
Yes
“When Inserting a CMOD, Simultaneously Rotate Handles Until They Touch the
Chassis” on page 35
Yes
“Video Output of CMM Is Distorted or Missing” on page 35 Yes
“SATA Drives Not Accessible Through NEM1 (CR 7003993)” on page 36 Yes
“Supported Rack Mounting Configuration” on page 36 N/A
“DIMM Population Rules” on page 36 N/A
“Supported Rack Mounting Configuration” on page 36 N/A
“Locking Screws Secure Shelf Rails to Rear Mounting Brackets” on page 39 Yes
“Message About Missing Disks After Failed Boot (CR 6939507)” on page 41 Yes
“System Does Not Power Up After Power Cycling (CR 6950414)” on page 41 Yes
“System Does Not Recognize DIMM Due to SPD Corruption (CR
6946921)” on page 41
Yes
Hardware Issues 31
To Next Page
Loading...
Need help?
General