Manual for Tire Pressure Monitoring Systems, TPMS
14/20
Mode 3: Front tires diagonal exchanged, and Rear tires parallel changed to Front.
Step
Operation process Photograph
1
Rotate the front tires diagonally to the rear, and the rear tires
parallel to the front. To prevent incorrect positioning, mark
the tires.
2
Press both the setup key and function key
simultaneously for 5 seconds. The display will flash green
and red, and a “beep” sound will be heard. You can release
the buttons, and the system will have entered into mode 1.
Re-press function key for 1 second and wait for “beep”
then the LED will show “2”, re-press the function key
again, and wait for “beep”, you will then see “3”, the system
will have entered into mode 3.
3
3-1
After entering mode 3, the display will show “3”
3-2
LED will flash diagonally for front to rear and parallel rear to
front in red.
3-3
The operator only needs to press the setup key for 1
second and listen for the “beep”. This means that mode 3
has been chosen and will exchange all four sensors ID
positions and will automatically return the monitoring status
to normal.
To Next Page
Loading...