Manual for Tire Pressure Monitoring Systems, TPMS
15/20
Mode 4: Random re-position tires
Step
Operation process Photograph
1
The tire shop will check the tire for abrasion and rotate tires
into the appropriate position.
2
Press both the setup key and function key
simultaneously for 5 seconds. The display will flash green
and red, and a “beep” sound will be heard. You can release
the buttons, and the system will have entered into mode 1.
Continue to press the function key ( the lower button), each
time for one second and each time wait for the beep until the
display shows”4”., After entering into mode 4 the LED will
show “4” and the tire LED light will be on tire :”1”. If sensor
on Tire No. “1” remains at the same position and need no
reconfiguration, please press the setup button to enter into
Tire No. “2” setup configuration.
3
3-1
After entering mode 4, the display will show “4”
3-2
When Tire No.1 needs to be reconfigured, deflate Tire No.1
once under 26 psi (tire low pressure default), and wait for
the receiver to receive the signal. When tire No. 1 receives
the signal, you will hear alarm “beep”. Then, start inflate the
tire No.1, it will keep on “beep” till Tire No. 1 is completely
inflated to normal pressure.
3-3
Tire No.1 LED will turn from red to green when Tire No.1 is
inflated to normal pressure, and now wait for tire No. 2.
To Next Page